Champion Juicer Parts

Champion juicer parts are the integral factor in designing a juicer intended for a long life of heavy duty use.

Juicer parts are made of 100% FDA approved nylon and tempered stainless steel. Even quality built parts suffer adversely with use; over time parts will wear and need replaced.

When in need of replacement parts, they are readily available via phone or online from Champion or from many other Champion juicer sale sites

PROS Heavy duty, built to last Stainless steel or tempered stainless steel FDA approved nylon Easy assembly Replacements readily available Replacements parts reasonably priced

CONS Parts are NOT dishwasher safe Nylon parts may stain

Featured Parts

• 1/3 HP General Electric heavy duty motor
• Cast cutter assembly
• Grain Mill Attachment
• Large and small hole screens
• Body and hub combo
• Containers, funnels, tampers, sieves
• Motor parts: Bearing, front end shield, oil seal, shielded hub, magnetic switchboard sensor, rear end shield and rubber feet

Review

Champion juicer parts are not dishwasher safe. Soak over night in soapy water for best results. If parts are stained bleach may be added to the water. Rinse thoroughly in warm water, dry and reassemble.

Champion juicers are not a disposable appliance. Champion juicer parts are available for motor repair or rebuilding as well as parts for the juicer processing assembly. Most part replacements may be performed by the owner.

Bearings and seals on the powerful 1/3 HP General Electric motor may be replaced simply but all other motor repair should be done by an appliance repair person to maximize the working life of the juicer.

The cutter assembly is completely and simply replaceable. Replacement timing is based on wear which is of course, contingent on use. Some customers have reported their cutters still effectively performing after 10 years. You can likely plan on replacing the cutter assembly every 18-24 months with heavy use.

The Grain Mill attachment enables grinding dry grains into flour with fine or course options. It is not recommended for nuts as they are oily and will plug the machine. Dry beans may also be ground. Parts for the Grain Mill are available to replace worn parts.

Interchangeable Champion juicer parts are available. Two type screens are interchangeable for determining how much pulp is allowed into the juice. The large holed screen allows approximately 50% more pulp through than the regular screen. Pulp contains mega-nutrition so it is nutritionally beneficial to allow more pulp into your juice.

If you have a use for the pulp, such as in muffins or quick breads, the regular screen will result in less pulp in the juice and more in the filter screen. Not only are these screen interchangeable but they are also replaceable.

The body and hub are easily replaceable. It is strongly advised to replace them at the same time and therefore sell as a combo pack.

Accessories such as containers, sieves, tampers and funnels are easily found online or by calling Champion Customer Service. Bearings, front end shields, oil seals, shielded hubs, magnetic switchboard sensors, rear end shields and rubber feet are all readily available replacement parts for the motor.

Champion juicer parts are easily obtained from various online Champion juicer sale sites. You can also phone your order to Champion Customer Service. Champion juicer parts are reasonably priced from $6.95 for a sieve to $59.95 for the hub and body combo pack. By replacing worn parts you will assure the maximum life for your Champion Juicer.